Setting Up and Adjustment
Drawbar Attachment
The separator can be raised or lowered to suit a variety of tractor drawbar heights by locating the ram pin in one of the 3 holes provided in the front lift ram bracket.
- Set the machine on firm level ground, preferably concrete or tarmac.
- Determine the required drawbar height.
- Fit the ram anchor pin in one of the holes to best suit the tractor drawbar height, (Fig 3.1.1, 3.1.2 or 3.1.3)
i.e. hole 1 for low tractor drawbars
- 2 for intermediate tractor drawbars
- 3 for high tractor drawbars.
- Lift the drawbar to meet the tractor drawbar and fit the hitching pin.
Drawbar Stand
A stand is provided to support the drawbar when unhitching from the tractor. It is not intended to bear the weight of the machine!
Note: Before using the stand make sure that hydraulic pressure is released from both front and rear lift rams and that the share is resting on the ground or on blocks.
- Remove the stand from the stowed position, fit in the upright position as shown (Fig 3.2.1) and secure in place using the pin provided.